< back

3 Point belts…. in the back 

We’ve installed a lot of these in the front seat, but very seldom in the back. Mounting them can be tricky because you want to keep the retractor upright while finding an adequate place so it keeps tension in the belt and retracts it when you push the button. The other over looked concern is spreading the load around and not just drilling a hole and bolting it in, it should have a thinker plate welded to the car to displace any load so the bolt doesn’t rip out in a worst case scenario 

This is the rear seat location in a 54 Chevy, We mounted the retractor on the front of the wheel well on a piece of 1/8 plate welded to the car -making sure that it’s level so the internal lock doesn’t always trigger, same goes for the 3rd anchor point in the middle of the wheel well 

And on the parcel tray we welded a 1/8 plate underneath the bolt area to secure the anchor point 

< back

Leave a Reply