< back

New Addition

 

I’ve been contemplating on the best way to do this for a while, I’ve got the louver machine -but it’s only good up to 5″, the bead roller only has a depth of 18″,  the Pullmax louver tool is the next option -but in the mean time I had this made up for my wheel.  I need to produce louvers of different sizes for the Bootch hood. So far on the practice runs everything went as planned, first I cut the sheet metal by hand to lay the pattern out, then roll back and forth, the profile of the louver causes some distortion at the ends but is easy to hammer out -the car is long and low and I wanted the louvers to reflect that.

< back

Leave a Reply